ESP8266-01S compatibility?

[Ante0]

I just bought an ESP8266-01S module. It seems to work fine, I see the 'pwned' AP. But I can't use the app on my flipper at all. It's like input is frozen? I can close it with Back but up/down etc are doing nothing. I've got it connected with 3.3v-3.3v, tx-rx, rx-tx and gnd-gnd. If I remove then put back 3.3v or ground the app reloads. So I feel like it should work? I don't have any 5v to 3.3v converters, but I suppose I could test just using resistors. I have noticed that sd card can't be read after using 3.3v output from the flipper, so maybe thats causing it?

[SequoiaSan]

Hi Ante0!

No, it's not compatible at this moment (and I'm not sure it will be), because you need more pins. Please, see the proper wiring

The behaviour of the SD card is caused by the 3v3 bus. The 3v3 bus is connected to the SD card directly and fuzzing or improper grounding causes errors to the SD chip if you'll do something wrong with this bus it may fry the SD chip, so be careful!

[skynet01]

This app here works with ESP8266-01S: https://github.com/Timmotools/flipperzero_esp8266_deautherv2 unfortunately it does not have a sweet DSTIKE like menu / interface so using it is a big pain in the ass. I think he would have to rebuild the app from the ground up to support the ESP8266-01S module.